MoreDat

A Student Network for Collaboration and Sharing

Signup on MoreDat.com

What’s Next For Electronic Devices. Have you heard of FPGAs? Find out now here. And as a bonus get your free guide to writing a successful resume. Just Signup now and it’s all yours free.

Every book has a different circuit drawn for the emitter follower circuit. My question is why is R1 and R2 needed in Figure 1 and why is it not included in figure 2.6?

What is R1 and R2 doing for the circuit in Figure 1?

What is V^- in Figure 1?

What is Rin and Rout?

Views: 84

Reply to This

Replies to This Discussion

In your first schematic, Figure 1, R1 and R2 are not necessary if you have picked appropriate values for V+, V- and RE.  The voltages and RE would determine the bias for the transistor.  If you were not able to provide appropriate voltages or if you wanted to be more assured of setting the bias point more precisely where you want it, then you would use the voltage divider network of R1 and R2.

Notice that in your second schematic, Figure 2.6, the emitter of the transistor is tied to ground.  As noted in the text above your figure it says “returning the emitter resistor to a negative supply voltage, you can permit negative voltage swings as well.”  What they are pointing out is that a negative going signal on your input would not produce any output unless you connect your emitter resistor to a negative voltage.

And your last question, “What is Rin and Rout?”, should use lowercase R as shown in the schematic.  r in and r out are the AC input resistance and the AC output resistance of the circuit which are more commonly referred to as input impedance and output impedance.

I hope this helps to clear up some things for you.

RSS

© 2024   Created by Jerome Trent.   Powered by

Report an Issue  |  Terms of Service